Lifebreath TFP3000 Manuel d'utilisateur télécharger pdf (Page 2)

TFP Directly Connected to

Forced Air Heating System

1. Install 7” port collar (provided) on top and

bottom of TFP (Fig. 1). Use (4) 8/32” X 3/8”

screws (provided).

2. Remove protective backing from pieces of

foam and stick them to the 4 corners of the TFP

on the side being mounted against the plenum.

3. Remove the 4 mounting bolts from the back of the

TFP cabinet. (Fig. 1)

4. Attach top and bottom mounting brackets

(provided) vertical to the TFP cabinet and

reinstall mounting bolts.

5. Lift the TFP into position. Edge of TFP must be

positioned on plenum to allow clearance

needed for latches.

6. Install the (4) 8/32” X 3/4” mounting screws

(provided) through the brackets and into position.

Tighten and secure.

7. TFP should now sit securely against the plenum

with the foam in between.

8. Cut 2 - 7” holes in the plenum. Install ducting to

join TFP to the return air plenum (Fig. 2).

NOTE: Do not support the weight of the TFP on

the duct. Duct must be open and not pinched.

NOTE: Due to possible noise transfer through

the duct system, it may be preferable in some

situations to hang the TFP a short distance from

the plenum, and connect by running flexible

ducting between them. Four nylon hanging straps

are provided for this option.

Type 1 Installation

* Direct connect to furnace/air handler return, or hang

separately and connect to plenum with flexible ducting.

TYPE 1 INSTALLATION

TFP

TFP air cleaner

TFP

Figure 1

Cold Air Return

Air flow direction

7" port collars

Access door

Power supply

Mounting bracket

Ducting (not included)

Clean (filtered) air port

Mounting bracket

Foam gaskets

FURNACE

Air Flow

Supply Plenum

Install plate here

1" Height

Figure 2

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire

Lifebreath TFP3000 Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Purificateurs d'air Lifebreath TFP3000